AUTONET TV

A Bright Spark (Ignition Coil Replacement)

Ever wonder how your vehicle’s engine is able to take the 12-volts from its battery and ramp that up to as high as the tens of thousands of volts it takes to fire its spark plugs? The secret is something called an ignition coil.  Most newer vehicles have an ignition coil at each cylinder, but older ones have a coil that serves all of the spark plugs. 

There are telltale signs that you have an ignition coil problem.  As you might expect, one symptom is it’s hard to start your engine or it won’t start at all.  If your engine is misfiring or not running smoothly or you see the Check Engine light come on, those all could point to an ignition coil failure.

Several things can contribute to ignition coil trouble in addition to normal wear and tear. Moisture and dirt may have gotten inside the coil, plus the heat and vibration of your engine over time can contribute to them going bad.  Bad spark plugs or plug wires can also be a cause.  

While ignition coils can last 100,000 miles/160,000 km, depending on how you drive and in what conditions.  If you start noticing some of the signs and symptoms just described, it’s a good idea to schedule a visit to see us so a technician can diagnose what’s wrong. Driving too long with an engine misfiring can damage your catalytic converter, and that can be expensive to replace.

A technician will thoroughly check your ignition system and determine where the failure is.  If it’s only one coil that’s bad, it may be the only thing that will need replacing.  If your vehicle has a distributor, it may also need to be replaced.  Properly-working ignition coils will help your vehicle operate at its best and help prevent future engine damage.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

Flat Tire? Three?s the Charm (Tire Repair)

For most drivers, at some point you’re going to have a flat tire. Depending on how it was damaged, it may have to be replaced.  But sometimes, a repair will do the trick, as long as the puncture isn’t on the sidewall and the hole is smaller than ¼ inch/6.35mm in diameter. Here are the three common ways your tire can be fixed.

One way is to put a plug in the hole.  Since most tires are damaged by running over sharp objects such as screws and nails, the small hole from which the air is escaping is on the part of the tire that touches the road. If it’s in the sidewall, it most likely can’t be fixed.  

In the plug method, a technician inserets a rubber plug.  It is covered with some sticky, gluey stuff, and is pushed into the hole from the outside. That plugs the hole and stays in place, thanks to the glue. Friction from driving heats it up and seals the deal.  

Another method is to patch the hole.  For this, your tire has to first be taken off the vehicle, then off the rim so the technician can get access to the inside. There, they’ll clean the inside surface around the hole and apply a rubber patch with an adhesive on it. This type of patch works well, and because of the extra steps and complexity, costs more than having your tire plugged.  

There’s also a combination of those methods just described, the plug-patch.  It is, in essence, a type of patch with glue on it that has a plug sticking out of it.  The plug is inserted into the tire from the inside and pulled through the hole from the outside, drawing the attached patch tight against the tire’s inside surface. The last two methods can’t be used if the hole is near another repair or the sidewall.    

The good news is if it’s fixed properly, your repaired tire should give you good service.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

Clean Machine (Fuel and Air Induction Cleaning)

As your vehicle ages, its performance isn’t quite what it used to be, but many of us never notice the change because it’s gradual.  So here are a few questions to ask yourself.  Does your vehicle feel like it doesn’t have the pep that it used to? Have you noticed your fuel economy isn’t quite as good as it once was? Does it idle roughly or is it hard to start?  Do you hear the engine knocking? Has it recently failed an emissions test?

All of those can be signs that your fuel and air induction systems are dirty and need cleaning.  Your fuel system takes gasoline from the tank to the engine’s combustion chambers where fuel injectors spray fuel that mixes with air and is ignited by spark plugs.  Black carbon deposits eventually can build up, obstructing fuel flow and diminishing your engine’s performance and fuel efficiency.

The air induction system is what allows air to go into the engine’s combustion chamber.  Getting the proper air flow is necessary for you to quickly start your vehicle, accelerate, and perform the way it should and idle smoothly when you’re standing still.  Like the fuel system, your air induction system can get blocked up with deposits and other contaminants.

A professional fuel and air induction cleaning can help restore your performance and fuel economy, especially when you are experiencing problems.  A technician will use specialized chemicals that can remove the carbon buildup.  In extreme cases, they will remove the fuel injectors and clean them with specialized tools.  

After cleaning, you may notice how much more pep your vehicle has and how smoothly it runs.  Keep your fuel and air induction systems clean and enjoy your vehicle’s performance improvements.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

Strutting Your Stuff (Shocks and Struts)

Ever wonder how your vehicle is able to move over bumps, potholes and other irregularities in the road and you hardly feel a vibration in the cabin? It’s your shocks and struts doing the hard work along with the rest of your suspension and tires.  They keep the ride smooth and are important for your vehicle’s safe operation. 

So, how do you know when your shocks and struts are wearing out? One way is to look at the surface of your tire (where the rubber meets the road—where the tread is).  You might see some little indentations in certain spots, known as tire cupping.  If your vehicle takes longer to stop than it used to, takes a dive when you hit the brake pedal or bottoms out (scrapes) on a big bump in the road, that’s another sign, as are loud, odd noises.

You may also notice your vehicle sways more than it used to. Every once in a while, look around at your shocks to see what shape things are in.  If you see the rubber cover cracked or worn out or see a fluid outside your shocks, those are signs to bring your vehicle in to us so we can see what’s going on. 

Since shocks and struts contribute to the safe operation of your vehicle, this service is important. Shocks and struts are what help your tires stay in close contact with the road and help stabilize your vehicle. They also help electronic safety systems work properly, including anti-lock braking, stability control, and collision avoidance.  Bad shocks and struts are just going to get worse with time.

It's best to have regular maintenance done before anything goes wrong with your struts and shocks.  Your vehicle’s manufacturer has guidelines for how long those intervals are.  If you do start to see some of the warning signs, head on over so we can evaluate any problems.  We’ll replace the parts your vehicle needs and have you strutting your stuff once again.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

A Clean Connection (Battery Cleaning)

A clean connection is a wonderful thing.  Think of a good cell phone signal or an airline connection with ample time and short distance to the next gate. Good connections are also important for your vehicle’s battery, and one secret to that is to make sure it’s periodically cleaned.

If it’s been a while since you have had any service to your battery, bring it in so we can inspect it for any corrosion that might have formed.  Corrosion on the battery terminals will affect the connection between the battery and your vehicle’s electrical system. The amount of corrosion you can expect can be influenced by such things as the kind of climate you live in (dry or humid, warm or cold), if there’s lots of salt on the roads and how old your battery is.  

We have tools and chemicals to safely remove the corrosion for an optimal electrical connection. In order to reduce the amount of corrosion re-forming on the battery, we’ll apply a special protective coating.  

It’s also important to have your battery tested, especially if it’s more than a few years old or hasn’t been tested in a while.  Our equipment can measure how well a battery holds a charge and how much more life you should expect from it. We can discuss when you might expect to buy a new one, since a battery is definitely the kind of thing you don’t want to have fail you when you’re least expecting it.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903